Télécharger Imprimer la page

Philips Beauty Initial HP4643/00 Mode D'emploi page 7

Publicité

ENGLISH
All manuals and user guides at all-guides.com
6
Introduction
This new Philips Initial straightener has been specially designed for fast
and easy straightening.The Initialstraightener has a short heat-up time
so you can quickly start straightening.The ceramic-coated plates ensure
easy gliding through the hair and ultra-smooth results.The comb on the
straightener offers extra convenience by guiding the hair.
General description (fig. 1)
A
Cool tip area
B
Ceramic-coated plates
C
Hanging loop
D
'Power on' pilot light
Important
Read these instructions for use carefully before using the appliance and
save them for future reference.
The HP4643 can be used at 100-240 volts AC.
For additional protection, we advise you to install a residual
current device (RCD) with a rated residual operating current not
exceeding 30mA in the electrical circuit supplying the bathroom.
Ask your installer for advice.
Keep this appliance away from water! Do not use this product
near or over water contained in baths, washbasins, sinks etc.
When used in a bathroom, unplug the appliance after use since
the proximity of water presents a risk, even when the appliance is
switched off.
This appliance gets very hot. Prevent the hot surfaces of the
appliance from coming into direct contact with the hands, eyes,
ears, face and neck. Do not touch the straightening plates when
the appliance is switched on.The plastic parts near the
straightening plates also become very hot during use, except for
the cool tip areas.
Keep the straightening plates clean and free of dust, dirt, styling
spray and gel. Never use the appliance in combination with styling
mousse, styling spray, gel etc.

Publicité

loading