Baby Jogger City Go Mode D'emploi page 23

All manuals and user guides at all-guides.com
INSTALLATION IN THE VEHICLE
20 Pull on shoulder portion toward the retractor
while pressing down on the center of the
carrier to tighten carrier to vehicle seat.
Note: Check to make sure carrier tight. Grab the
sides of the seat and slide the carrier side to
side and front to back. If the carrier moves
less than 1.5 cm, it is tight enough.
REMOVING THE FABRIC
21 On the side of the canopy, pull the tab and
detach the canopy frame.
22 Remove the seat cover by lifting around the
side edges and pulling off from the front foot
area.
CARE AND MAINTENANCE
23 Store instruction manual under the the seat
pad in the groove in the seat.
Periodically inspect your child seat for worn or
damaged parts. If damaged parts are found,
replace the child seat. Keep the child seat
clean. Do not lubricate or oil any part of the
seat.
CLEANING THE COVER
The fabric parts can be cleaned according to
the instructions on the washing label.
19