Ingersoll Rand 301 Manuel D'instructions page 3

LUBRICATION
Ingersoll–Rand No. 10
Always use an air line lubricator with this tool.
We recommend the following Filter–Lubricator–Regulator
Unit:
For International – No. C01–C2–T29
For USA – No. C05–02–G00
After each two hours of operation, if an air line
lubricator is not used, inject 1/2 to 1 cc of Ingersoll–Rand
No. 10 Oil into the Air Inlet.
Periodically as experience indicates, remove the Spindle
Bearing Cap and lubricate the Pinion and Pinion Gear
with 2 cc of Ingersoll–Rand No. 67 Grease. Excessive
lubrication will cause grease to work out around the
Spindle Collet Body.
Model Type of
Handle
301 Inline
H
Tested in accordance with ANSI S5.1–1971 at free speed
♦ Tested in accordance with ISO8662–1 with artificial unbalanced load at 50% of rated speed for ungoverned tools and at
80% rated free speed for governed tools.
•
ISO3744
All manuals and user guides at all-guides.com
PLACING TOOL IN SERVICE
Ingersoll–Rand No. 67
SPECIFICATIONS
Collet size Free
Speed
1/4" 20,000
MAIN LINES 3 TIMES
AIR TOOL INLET SIZE
TO
AIR
SYSTEM
TO
AIR
TOOL
LUBRICATOR
REGULATOR
BRANCH LINE 2 TIMES
AIR TOOL INLET SIZE
DRAIN REGULARLY
HSound Level
dB (A)
•Power
Pressure
91.8
3
FILTER
COMPRESSOR
(Dwg. TPD905–1)
♦Vibrations
Level
2
m/s
104.8 0.8