König Electronic SAT-MOD12 Manuel D'instructions page 2

Audio/Video PLL mono modulator
Power supply: 230 V / 50 Hz
Video input: 1 Vss
Video output: 0.7 Vss
RF output: 70 dBμV, channel 21-69
Standard: PAL G
With the SAT-MOD12 PLL Modulator you will be able to distribute the video and audio signal from
any source to all the TV-sets of the house. The SAT-MOD12 is especially useful for digital satellite
receivers and DVD-players without internal modulator.
• Choose the output channel at a free RF channel at your antenna installation. See the channel table
at the end of this user manual.
• Keep switch 1 at the OFF position in order to provide the test signal.
• If you see any contrast differences between the pictures of SAT-MOD12 channel and the
standard channels try to adjust very carefully the video level (at the bottom of the modulator).
Safety precautions:
Maintenance:
Clean only with a dry cloth. Do not use cleaning solvents or abrasives.
Warranty:
No guarantee or liability can be accepted for any changes and modifications of the product or damage
caused due to incorrect use of this product.
General:
- Designs and specifications are subject to change without notice.
- All logos, brands or brand logos and product names are trademarks or registered trademarks of their
respective holders and are hereby recognised as such.
- This manual was produced with care. However, no rights can be derived. König Electronic can not
accept liability for any errors in this manual or their consequences.
- Keep this manual and packaging for future reference.
Attention:
This product is marked with this symbol. It means that used electrical and electronic products
should not be mixed with general household waste. There is a separate collections system for
these products.
ENGLISH
To reduce risk of electric shock, this product should ONLY be
opened by an authorised technician when service is
required. Disconnect the product from mains and other
equipment if a problem should occur. Do not expose the
product to water or moisture.
2