Bimar BW-627C Notice D'instructions page 13

and at least 50cm at the sides.
- the appliance is away from other sources of heat, flammable materials (curtains,
upholstery, etc.), flammable gases or explosive materials (spray cans) and materials that
can be deformed by heat.
•
This appliance must not be used in any type of vehicle or restricted space (lifts,
camper vans, cars, cabins etc.).
•
Attach the wall heater using the 4 screws provided, using the holes found on the
back of the casing. Ensure that the appliance is disconnected from the plug point
before attaching it.
•
Ensure that the power cable is correctly positioned and does not come into contact
with hot parts or sharp edges, or become wound around the device itself and is not
twisted.
Fig.1
USING THE APPLIANCE
The heater is equipped with a "pull switch", to select the power output of the
heater, and with a display that shows what has been selected:
0=off 1= 500W 2= 1000W 3=1500W.
The selected modes follow on from each other by pulling the cord.
Adjust the angle of the heating part to direct the infra-red light and heat.
If there is a fault or the appliance is not working correctly, switch it off and have
it checked by a qualified professional. Repairs done by an unqualified person
can be dangerous and cause the guarantee to become void.
To turn off the heater, pull the "pull switch" until the "0" appears on the display
and remove the plug from the plug point.
If the appliance is not being used for long periods of time, remove the plug from
the plug point.
13