Publicité
Les langues disponibles
Les langues disponibles
Operating Instructions
3.5mm SYNC
socket
GROUP switch
Frequency
channel selector
1. Connect the SYNC cable to the EL-Skyport SYNC socket and the flash unit SYNC socket.
Use included SYNC cable.
2. Check the correct Group and Channel setting for the Transmitter and
Universal Receiver.
3. Switch ON the EL-Skyport Universal Receiver and Transmitter
4. Switch flash unit ON and press "TEST" push button on EL-Skyport Transmitter for a Test
flash.
Operating Modes
1. Battery mode: Charge LED flashes when switched ON. If not used for 4 hours, the unit
will switch to Stand-By Mode (switch Receiver OFF and ON to return to normal mode)
2. Supply mode: With Wall-Adapter Charger plugged in for long term fixed operation
Note:
If the EL-Skyport Receiver is used whilst charging (in Supply Mode), the Universal Receiver
will not change to Stand-By mode.
4
All manuals and user guides at all-guides.com
Charge socket for
EL-Skyport Wall Charger only
ON/OFF switch
Status LED (green)
Flexible swivel
Antenna 360 ̊
Fig. 1
Frequency Channel
Note:
Transmitter and the corresponding RX Transceivers or Universal Receivers must have
the same frequency channel setting !
Slide Button configuration
Frequency
Channel
1
1 (default)
Off
Off
2
On
Off
3
Off
On
4
On
On
5
Off
Off
6
On
Off
7
Off
On
8
On
On
Note:
After changing the frequency, switch Receiver OFF and ON again to activate the new settings.
Trigger Group Settings
The EL-Skyport Transmitter triggers the Universal Receiver in following modes:
1. Groups(1 to 4) sets and triggers flash units in different "Groups"
è only Flash Units with the selected Group are triggerd by the Transmitter
(Group setting must correspond between Transmitter and Receiver)
2. ALL
Transmitter is set to ALL
è The Transmitter triggers all EL-Skyport Receivers
Trigger
Frequency
2
3
/ Mhz
Off
2456
Off
2458
Off
2460
Off
2462
On
2469
On
2471
On
2473
On
2475
Remote
Frequency
/ Mhz
2448
2450
2452
2454
2461
2463
2465
2467
5
Publicité
