Publicité
Les langues disponibles
Les langues disponibles
Owner's manual
Note:
• Always pull the plug, not the cord!
• While rewinding the power cord, guide it with a hand to ensure that
it does not whip causing damage or injury.
Important
The appliance has thermal protection. If the vacuum cleaner overheats, the
thermostat will automatically turn it off. It can be caused by dirty or blocked
filters, full dust bag or jammed hose, tube or nozzle. In that case, disconnect
the appliance from the power supply socket and press the Power button.
Change the dust bag, clean the filters and check if any part of the vacuum
cleaner is blocked. Allow the appliance to cool for approximately 1 hour.
Then connect the appliance to the power supply socket and turn it on. If the
appliance keeps turning off despite following those instructions, consult
the authorized service point. Do not allow the appliance to overheat and
turn off regularly as this may lead to the motor damage.
Changing the dust bag
Note:
• When the Dust bag full indicator lights red, it indicates that the dust bag
needs to be replaced.
• The Dust bag full indicator also lights red when the nozzle, tube or filter
is blocked by dirt. Get rid of dirt or a blocked object and turn on the
appliance again.
• Before changing the dust bag make sure the appliance is disconnected
from the power supply socket.
1. First, remove the hose from the hose socket. To do this, press locking
buttons on the side of the hose and pull it out.
2. Release the front cover fastening and open the front cover.
3. Slide the dust bag holder up.
4. Slide the dust bag out of the holder:
• paper dust bag- it should be replaced with a new one each time;
• textile dust bag- it should be cleaned by tapping out dirt. Do not wash
the textile dust bag in a washing machine!
5. Insert a new paper dust bag or a cleaned textile dust bag in the holder
and then into the vacuum cleaner compartment.
6. Close the front cover.
25
EN
Publicité
