Publicité
GB
Atik R2
User manual
Thank you for purchasing the Lightpro Atik R2.
This document contains the required information for
correct, efficient, and safe use of the product. Consult
the general manual of the Lightpro 12-volt system
and the user manual of your transformer for more
information about the set up and connection of your
light plan.
Read the information in this manual carefully before
using the product. Keep this manual near the product
for consultation in the future.
PRODUCT DESCRIPTION
The Lightpro Atik R2 is an LED spot for outdoor use.
The fixture can be installed in a fixed underground
with the included screws, or be placed in the ground
with the included ground tube. This product may only
be used as outdoor lighting in combination with the
Lightpro 12-volt system. Any alterations made to the
product may have consequences for the safety, gua-
rantee, and correct functioning of the product and/or
other parts of the system.
Specifications
Product
Article number
Power (max.)
Luminous flux
Dimensions (H x Ø)
Protection class
Ambient temperature
Cable length
Dimmable
INSTALLATION
Packaging content
[Figure A]
1. Fixture Atik R2
2. Ground tube
3. Lightpro connector
4. Alternative reflector
Check if all parts are present in the packaging. For
questions about parts, service, and any complaints or
other remarks, you can always contact us. E-mail: info@
lightpro.nl
Lightpro Atik R2
187U
9W
65 – 750 lm
115 x 120 mm
IP67
-20°C to 50°C
1m
Yes, with built-in dimmer
Option 1: placement in de ground
[Figure B]
1. Place the ground tube in the ground.
2. Place the fixture in the ground tube.
The push button for setting the built-in dimmer is
located at the underside of the fixture. To control the
dimmer, the fixture has to be (temporarily) removed
from the ground tube. When installing, sufficient cable
length has to be reserved to be able to reach the
dimmer.
Option 2: placement in a fixed underground
[Figure C]
1. Drill a hole (Ø100 mm) in the underground.
2. Place the fitting in the drilled hole. The ground tube
does not need to be used.
ADJUSTING BEAM DIRECTION AND/OR CHAN-
GING THE REFLECTOR
The pre-installed reflector has a beam angle of 60°.
If desired, it can be replaced by the included alterna-
tive reflector, which has a beam angle of 23°.
[Figure D]
1. Unscrew the cover ring.
2. Remove the cover ring from the fixture.
[Figure E]
1. Unscrew the reflector.
2. Remove the reflector.
3. Place the alternative reflector (Figure A [4]).
4. Fasten the reflector.
[Afbeelding F]
The light source is secured in place by a spring
mechanism.
1. Pull the light source holder away from the fixture,
putting tension on the spring.
2. Keep the spring in tension, and move the holder of
the light source to the desired position.
[Afbeelding G]
1. Place the cover ring on the fixture.
2. Properly fasten the cover ring.
DIMMER FUNCTION
The fixture is equipped with a built-in dimmer. The
light output can be set to 6 different levels.
[Figure H]
• Push the button to set the desired light output.
Publicité
