LightPro Castor 3 Manuel De L'utilisateur page 8

Castor 3
User manual
Thank you for purchasing the Lightpro Castor 3.
This document contains the required information for
correct, efficient and safe use of the product. Consult the
user manual of your transformer for more information
about the installation and connection of your lighting
plan or visit our website www.lightpro.nl
Read the information in this manual carefully before
using the product. Keep this manual near the product for
consultation in the future.
PRODUCT DESCRIPTION
The Lightpro Castor 3 is an LED spot for outdoor use. The
fixture can be mounted on a solid surface or placed in
the ground with the supplied spikes. This product may
only be used as outdoor lighting in combination with
the Lightpro 12-volt system. Any alterations made to the
product may have consequences for the safety, guarantee
and correct functioning of the product and/or other parts
of the system.
SPECIFICATIONS
Product
Article number
Light source
Power (max)
Luminous flux (max)
Light colour
Average lifetime
Dimensions (H x B x W)
Protection class
Ambient temperature
Cable length
Dimmable
Light source
On/off
PACKAGING CONTENT
[Figure A]
1. Fixture Castor 3
2. Ground spike
3. Screw
4. Plug
5. Lightpro connector
6. Hex key (large)
7. Hex key (small)
Lightpro Castor 3
177S
LED 2,5W AC/DC 12V
2,5W
200 lm
3.000K
25.000
120 x 60 x 100 mm
IP44
-20 °C to 50 °C
1m
No
Not replaceable
10.000
Check if all parts are present in the packaging. For
questions about parts, service, and any complaints or
other remarks, you can always contact us.
E-mail: info@lightpro.nl.
INSTALLATION
Option 1: placement on a fixed underground or mounting
to a wall
[Figure B]
1. Remove the screw from the base using the included
large hex key (Figure A [6]).
2. Remove the fixture from the base.
[Figure C]
• Install the base onto the underground with the included
screw.
If necessary, drill a hole in the underground and use
the included plug.
[Figure D]
1. Place the fixture in the base.
2. Place the screw in the base.
3. Put the fixture in the desired position.
4. Fasten the screw using the included large hex key
(Figure A [6]).
Option 2: placement in the ground
[Figure E]
1. Place the spike underneath the base.
2. Properly fasten the spike.
3. Put the fixture in the desired position.
4. Fasten the screw using the included large hex key
(Figure A [6]).
5. Place the fixture in the ground.