Table des Matières
Publicité
GB
Juno 2 / Juno 4
User manual
Thank you for purchasing the Lightpro Juno.
This document contains the required information for
correct, efficient and safe use of the product. Consult
the general manual of the Lightpro 12-volt system
and the user manual of your transformer for more
information about the set up and connection of your
light plan.
Read the information in this manual carefully before
using the product. Keep this manual near the product
for consultation in the future.
PRODUCT DESCRIPTION
The Lightpro Juno is a LED spot for outdoor use. The
fixture can be installed on a fixed underground with
the included screws, or be placed in the ground with
the included spike. This product may only be used
as outdoor lighting in combination with the Lightpro
12-volt system. Any alteration made to the product
may have consequences for the safety, warranty, and
correct functioning of the product and/or other parts
of the system.
Specifications
Product
Article number
Power
Luminous flux
Dimensions (h x Ø)
Protection class
Ambient temperature
Cable length
Dimmable
INSTALLATION
Packaging content
[Figure A]
1. Fixture Juno
2. Baseplate
3. Screw
4. Screw
5. Spike
6. Screws
7. Plugs
8. Lightpro connector
9. Hex key
Lightpro Juno 2 / 4
193S / 194S
2 / 4 W
192 / 372 lm
85 x 55 x 68 mm
IP44
-20°C to 50°C
2m
No
Check if all parts are present in the packaging. For
questions about parts, service, and any complaints or
other remarks, you can always contact us.
E-mail: info@lightpro.nl
Option 1: Placement on a fixed underground
[Figure B]
Mount the base [2] on the surface with the included
screw [6]
If necessary, drill a holes in the underground and
use the included plug [7]
[Figure D]
1. Attach the fixture [1] to the foot [2] with the screw [3]
2. Set the fixture to the desired position
3. Fasten the screw [3] using the included hex key [9]
[Figure F]
Ready
Option 2: Placement in the ground
[Figure C]
Mount the base [2] on the spike [5] with the included
screw [4]
[Figure E]
1. Attach the fixture [1] to the base [2] with the screw [3]
2. Set the fixture to the desired position
3. Fasten the screw [3] using the included hex key [9]
[Figure G]
Place the fixture in the ground
Publicité
Table des Matières
