Kolcraft Contours Options S70-T Mode D'emploi page 9

6
To Attach Infant Car Seat Adapter
Infant Car Seat Adapter Catches
Frame Hub & Button
All manuals and user guides at all-guides.com
4 - 7
Front Sticker
1
2
9
Slide Rear Wheel onto axle.
4
Slide Washer onto axle.
5
Fit straight part of Cotter Pin through
6
hole on axle as shown.
Line up tabs in the Hub Cap with slots in
7
the wheel, snap hub cap into place.
Repeat for second side.
8
(select models)
Align Infant Car Seat Adapter catches
1
over frame hubs as shown and push
Infant Car Seat Adapter down onto the
frame hubs until a "Click" is heard. Make
sure the "Front / Frente" sticker on the
adapter is facing the front of the stroller.
The button on the frame hubs should be
2
seen through both Infant Car Seat
Adapter catches. Pull up on the Infant
Car Seat Adapter to make sure it is
securely attached.
NOTE: To remove Infant Car Seat
Adapter , push both buttons on the frame
hub in, then lift the Infant Car Seat
Adapter up.
Attaching a Second Infant Car Seat
Adapter
(sold separately - through Consumer
Service see page 59)
Follow Steps 1 and 2, by installing the
Infant Car Seat Adapter to the frame
hubs towards the front of the stroller.