Publicité
Les langues disponibles
Les langues disponibles
W
C50 IN
INEMASTER
3. USING THE WINEMASTER C50 IN AIR-CONDITIONER
3.1 CONNECTING THE AIR-CONDITIONER
Connect the male plug to a 230V / 16A power socket. Switch on the air-conditioner by pressing button 2 on the
diagram below. The fan on the cellar side comes on immediately. The compressor may not come on until 2 minutes
later if the temperature in the cellar is higher than the set temperature. If the cellar temperature matches the
thermostat setting, the compressor will not come on.
If you want a setting temperature more quickly, you can press button 2 on position II. I this case, the speed of air
circulation increase and the wine cellar will reach nominal power.
For the cellars wich volume is higher than 20m3 (this volume could change according the insulation condition). It is
advisable, specialy during heat period, to always remain with position II.
3.2 CONTROL PANEL
The setting of the targeted temperature of the cellar is made on the thermostat .
Use the following process :
Press the button 3 one seconde until the message o1 appears. Press then the button 5, the set temperature of
the cellar will appear. Use again the button 3 to increase the temperature or the button 4 to lower the temperature.
When the right temperature is set, press the button 5 to confirm it.
3.3 AUTOMATIC DEFROST
The program of the thermostat will run an automatic defrost time several times a day.
During this position, the compressor cannot sart. Only the fan in the cellar can function.
The condensate water produced during this period will be evacuated through the tube
USER GUIDE
3
The air-conditioner is equipped with an electronic
thermostat fitted to the front of the device so that the
operating status of the WINEMASTER can be seen at any
time from inside the cellar.
5
The thermostat permanently displays the temperature of
the air in the cellar which varies in range of 2 °C. The
variation of the air temperature carries a smaller variation
than the wine's one due to the thermal inertia of the liquid.
4
The thermostat as been set by factory at 12°C. When you
start the cellar wine, you should verify and, if need, modify
1
the temperature following instructions below.
The on/off button IOII (reference 1 in diagram) allows you
to start the air conditioner and select the level of
ventilation within the cellar.
The button IO (reference 2) when lit up in green indicates
2
the electricity connection of the unit and allows you to
illuminate the integrated flourescent lamp.
O
2006
CTOBER
Page 29
Publicité
