Kärcher BR 30/4 C Mode D'emploi page 16

Maintenance Works
Replace the vacuum bar.
Note
The vacuum bars are attached to the appli-
ance with snaps and can simply be pulled off.
 Move the suction bar lift pedal to posi-
tion „suction off" (Fig. 3 - position "1/
ON", see inside front cover).
 Remove the fresh water reservoir.
 Remove the dirt water reservoir.
 Lay the device on the reverse.
 Pull off the vacuum bar downwards.
 Insert the new vacuum bars and lock
them into place.
Replacing the brush roller
 Remove the fresh water reservoir.
 Remove the dirt water reservoir.
 Lay the device on the reverse.
 Press the release button for the brush
roller and swivel the brush roller toward
the bottom and pull it off the driver.
 Place the new brush roller on the driver
and lock into place on the opposite side.
Frost protection
In case of danger of frost:
 Empty the fresh and dirt water reser-
voirs.
 Store the appliance in a frost-protected
room.
16
Danger
Risk of injury by inadvertent startup of ap-
pliance and electrical shock.
First pull out the plug from the mains before
carrying out any tasks on the machine.
Caution
Risk of damage to the appliance on ac-
count of water leakage. Empty the waste
water reservoir and the fresh water reser-
voir prior to performing maintenance on the
appliance.
In case of faults that cannot be remedied
using the table below please contact the
customer service.
– 5
EN
Faults