GE PFD95 Guide De L'utilisateur Et Instructions D'installation page 6

Getting started
Power
A
Press to "wake up" the display. If the display is active, press to put the dryer into idle mode.
NOTE: Pressing Power does not disconnect the appliance from the power supply.
Start and Pause
B
Press Start to begin the cycle. NOTE: The door must be closed for the dryer to start the cycle. Pressing Start
again will pause the cycle, the Start light may blink and "Pause" will display.
To continue the cycle, press Start again.
Display and Status Lights
C
The display shows the approximate time remaining until the end of the cycle. On some models, the dryer cycle
status (Sense, Drying, Damp and Cool) will be shown.
In addition, the display will show:
(WiFi)
(on some models)
Controls
Check Filter
Check Vent
(on some models)
(on some models)
6
Will allow your appliance to communicate with your smartphone for remote appliance
monitoring control and notifications.
The dryer is locked - will blink once if you press any pad or turn the cycle knob.
The Check Filter light will stay on for 15 seconds after the cycle stops.
The Check Vent light indicates an issue has been found due to reduced airflow from a possible
blocked or restricted vent. Checking and/or cleaning the vent system is recommended. See the,
"Check Vent" light is on in the Troubleshooting Tips section.
Your dryer is equipped with Artificial Intelligence capabilities. This indicator will illuminate when
Washer Link is active, My Settings are being implemented based on your usage habits and
suggested actions are available through the SmartHQ app.
This is a pairing feature for use with a compatible Bluetooth
washer. To pair this dryer with the washer, please follow the steps outlined in the washer's
Owner's Manual. To engage or disengage Bluetooth
within 10 seconds when the dryer is powered on but not actively running a cycle.
® enabled GE Appliances frontload
® , open and close the door three times
49-3000206 Rev 8