GE PFD95 Guide De L'utilisateur Et Instructions D'installation page 30

EXHAUSTING THE DRYER (cont.)
BOTTOM VENTING (cont.)
• Locate the 12-1/2" (31.5 cm) exhaust duct and
elbow duct from the kit and assemble together.
Apply aluminum foil tape around the joint to eliminate
leaks between ducts.
12-1/2" (31.5 cm)
• Insert and connect the elbow/exhaust duct
assembly to the blower housing and insert the
elbow through the bottom knockout.
30
Installation Instructions
BOTTOM VENTING (cont.)
• Install the new access panel from the kit.
• Secure access panel with 4 screws saved from
earlier.
NEVER LEAVE THE BACK OPENING WITHOUT
THE ACCESS PANEL.
49-3000206 Rev 8