Klarstein Reinraum 2G Mode D'emploi page 22

8. To vacuum large quantities of liquid, from a sink or tank etc., do not immerse the nozzle completely in
the liquid; leave a gap at the top of the nozzle opening to allow an air inflow. The machine is fitted with
a float valve which blocks the suction action when the tank has reached its maximum capacity. The
user will notice an increase in motor noise. When this happens, turn off the machine, disconnect from
power supply, remove the head from the tank and empty the liquid into a suitable receptacle or drain. To
continue vacuuming, refit the head and proceed. After wet vacuuming, turn the machine off and remove
plug from power supply. Empty the tank and clean/dry the inside and outside before storage.
Carpet cleaning
Set-up
Water, mixed with a suitable carpet shampoo solution, is pumped deep into the fibres of the carpet via the
shampoo application nozzle. The dirty liquid is then sucked back into the waste tank along with the dirt and
grime dislodged by the cleaning solution. Water can be pumped up to 2 meters above the machine so that
stairs may also be shampooed.
22
Cleaning attachment