IB RUBINETTI PURO 383 Notice De Montage page 10

EN
FIRST START-UP
FUNCTIONAL VERIFICATION
Make sure that the flexible hoses are well fixed, that too tight bends do not appear and that in any
case they are not crushed for any reason.
If the operation has not yet been performed, open the CO2 cylinder.
Open the water mains taps.
Check that all the hydraulic connections do not show any drips or leaks of any kind.
Connect the appliance to the mains by inserting the plug, then turn on the refrigerator under sink.
Now turn the thermostat adjustment knob, located on the back of the appliance,
to position "4" (= medium). The refrigeration unit will start to work and its subsequent shutdown
will indicate that the water temperature has reached the average temperature level set with the
thermostat.
Dispense cold natural water until the water without air bubbles has completely flowed out (about
10 liters).
SPARKLING WATER FLOW REGULATION
In order to avoid annoying emptying of the saturator with the consequent release of only CO2
during the dispensing of sparkling water, it may be necessary to change the calibration of the flow
regulator.
Before this adjustment, it is necessary to adjust the carbon dioxide pressure and possibly also that
of the feed water.
• Rotating clockwise, the flow decreases and the amount of sparkling water produced increases;
• Rotating counterclockwise, the flow increases and the amount of sparkling water produced
decreases
Warning: do not unscrew completely
the sparkling water pressure reducer
to avoid water leaks.
CLEANING
For correct cleaning, wash only with soap and water, rinse and dry with a chamois leather and soft
cloth. Absolutely avoid the use of alcohol, solvents, solid or liquid detergents containing corrosive
or acidic substances, cloths with synthetic fibers, abrasive sponges, pads with metal threads, as
they could irreversibly alter the treated surfaces.
THE USE OF THIS TYPE OF DETERGENTS FOR CLEANING THE TAP INVOLVES ANY WARRANTY ON
THE SURFACE OF THE TAP BY IB RUBINETTERIE.