Door Reversal Instructions - Danby DCR016C1BDB Guide D'utilisation Et Soins De Propriètaire

Installation Instructions
DOOR REVERSAL
INSTRUCTIONS
• Ensure the appliance is unplugged
and empty.
• We recommend that 2 people handle
the refrigerator during assembly.
• Adjust the 2 leveling feet to their
highest position.
Tools Required
Cross-bladed screw driver - Phillips head
*NOTE:
• To take the door off it is necessary to
tilt the appliance backward.
• You should rest the appliance on
something solid e.g a chair just
below the top panel.
DO NOT lay the appliance completely
flat as this may damage the coolant
system.
If you find the direction of opening the door on your appliance
inconvenient, you can change it by following the diagram below.
CAUTION
To avoid personal injury to yourself and/or property, we recommend
someone assist you during the door reversal process.
1 Remove the plastic hole covers
which are located on the top left
side of the refrigerator as shown in
Figure 1.
2 Remove the upper hinge and hinge
cover on the right side of the refrig-
erator, as shown in Figure 2.
3 Remove the door and incline the refrig-
erator at an angle of 45 degrees. You
should rest the refrigerator against
something solid so that it will not slip
during the door change process. Do
not lay the refrigerator flat as this may
damage the coolant system. On the
underside of the refrigerator, remove
the lower hinge bracket on the right
side and the leveling foot on the left
side and reverse their positions as
shown in Figure 3.
4 Install the lower hinge on the left side
on the bottom of the refrigerator.
Install the adjustable foot on the right
side as shown in Figure 4.
5
Figure 1
Figure 2
Figure 3
Figure 4