Publicité
Les langues disponibles
Les langues disponibles
Instruction Manual
GB
Safety
1. Read carefully before usage.
2. The Skim 300- 500-750 and 1250 are is only suitable for indoor use.
3. Ensure voltage shown on the label match to the mains supply voltage.
4. Ensure that water cannot reach the socket.
5. Never let the pump run dry, keep it submerged at all times.
6. Disconnect skimmer from mains before any maintenance on your aquarium.
7. If damaged the supply cord cannot be replaced, the whole pump needs to
be replaced.
8. This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction concerning use of the
appliance by a person responsible for their safety. Special care should be taken
with the use of electrical equipment by or near children.
Installation Skim 300
1. Unscrew the 4 nylon screws on the
bottom plate (15) and disconnect the air
venture (9).
2. Lift the skimmer body off.
3. place the bubblecatcher in front of the
wateroutlet in the skimmerhousing (13).
4. Put the skimmer body back in place and
secure with the 4 nylon screws (15).
5. Re-assemble the air venture (9).
6. Connect the air venturi (9) to the air
silencer (4) by using the supplied air
hose (7).
7. Place the skimmer inside your sump and
open the water outlet fully by using the
adjusting knob (12).
8. Plug the pump in to the power outlet.
9. Adjust the level of skimming by turning
the knob (12) adjusting the
water outlet (14).
10. Be careful using the skimmer just after
you have filled your tank with freshly
mixed salt as this can cause extreme
foaming and overflow.
Installation Skim 500, 750 and 1250
1. Unscrew the 4 nylon screws on the
bottom plate (15) and disconnect the
air venture (9).
2. Lift the skimmer body off.
3. Adjust the first bubble plate so that the
clear part is facing above the pump
outlet (13).
4. Re-assemble the second bubble plate and
secure with the nylon screw (14).
5. Put the skimmer body back in place and
secure with the 4 nylon screws (12).
6. Re-assemble the air venture (9).
7. Connect the air venturi (9) to the air
silencer (4) by using the supplied air hose.
8. Place the skimmer inside your sump and
open the water outlet fully (by rotating the
arrows towards each other) by using the
adjusting knob (10).
9. Plug the pump in to the power outlet.
10. Adjust the level of skimming by
turning the knob (10)
11. Be careful using the skimmer just after
you have filled your tank with freshly
mixed salt as this can cause extreme
foaming and overflow.
4
Publicité
