Publicité
Les langues disponibles
Les langues disponibles
SNOWPLOW ASSEMBLY
adjustment pin so that the frame is horizontal and the blade vertical.
14. Hook the trip springs (18, fig.15) into the holes in the top cross rib at the back of
each plow blade panel (37/38h, fig.15). Attach the springs to the angle plates on
the D frame (5a, fig.15) using for each an M12 gr.8 eyebolt (17, fig.15), M12 nut,
2 12 mm washers and an M12 Nylock nut.
15. Tighten the Nylock nuts to the point where the springs are just tight. Then turn
the Nylock nut, shortening the take-up by 6 mm (1/4 inch) further so the springs
open slightly. Snug up the inner M12 nut to hold the assembly tight. Assemble
the blade angle locking handle with knob to the A frame so that it operates the
spring-loaded angle lock pin in the bracket on top of the A frame smoothly. Bolt
the end of the handle opposite the knob (16, fig.16) to the eye in the small tab in
the A frame's centre cross piece (6t, fig.16) with an M8 x 25 mm gr.8 bolt (48,
fig.16) and 2 x 8 mm washers. Secure with an 8 mm Nylock nut. Bolt the handle
to the hole in the angle lock pin with an M8 x 35 mm gr.8 bolt (49, fig.16) and 2
x 8 mm washers. Secure with an 8 mm Nylock nut.
16. Attach the snow deflector to the top flange of the plow. Place the deflector
rubber along the top angle of the plow blade. On top of that place the short and
long metal deflector battens.Bolt them into place with 7 M10 x 25 mm carriage
bolts down through all but the two end holes. In the end two holes, insert the
threaded ends of the two snowplow marker wands. Secure all with 9 x M10
Nylock nuts threaded on from below the flange.
17. Using two bolts and nuts, attach the light bar with the two lights to the top edge
of the winch support tower.
18. Connect the safety chain to the bottom of the winch mounting plate with the
threaded quick link. During transportation with the plow blade raised, the
clip hook should fasten to the hole in the angled tab just behind the strap
attachment point in the apex of the A frame, preventing the plow blade from
falling should anything fail.
19. It is normal for the whole assembly to rock back and forth when mounted,
with the plow blade moving side to side from 20 to 25 cm (8 to 10 in.) This
compensates for differences in terrain between the surface the plow rides on
and what the vehicle is riding on. This flexibility should not be reduced.
ELITE SERIES ACTUATOR ASSEMBLY
z see fig.17
1. Attach the Actuator mounting bracket, part #59 to the main frame.
2. Using hardware #64 Hex bolt (1/2"-13 x 3", bolt part #58 Actuator pivot arm, to
#59, the Actuator mounting bracket, through the center hole.
3. Part #66 Actuator safety pin, goes through the end of part number 58, the
Actuator pivot arm.
4. Use hardware #63, Hex bolt (1/2"-13 x 2-1/2") to mount #60, the Electric
actuator to #58, the Actuator pivot arm.
5. Insert the Lifting chain, #61, through the Actuator safety pin, #66
and fasten the top to #58,. the Actuator pivot arm.
6. Using the U-Bolt (#10), inserted in the A-frame (#5), fasten the other
end of the chain.
En.12
DK2SPII man
Publicité
