König SAS-DVRPIR10 Mode D'emploi page 4

3. For operation on the motion detector itself
(otherwise use the remote control), press the
trigger button. When motion is detected,
the standby indicator flashes once and goes
out. To end the function, press the trigger
button again. The standby indicator will light
up again.
4. The motion detector can also be operated by
the remote control.
A: Start manual recording (motion detection is
disabled and the motion detector will record
constantly until the stop button is pressed)
B: Stop manual recording
C: Enable motion detection
D: Disable motion detection
Note: The remote control has infrared transmission, which prompts you to point the remote
control towards the motion detector for operating.
5. The motion detector can be connected
directly to a monitor or TV for live view or
playback function.
Use the AV cable to connect.
When connected to a monitor or TV, the
following indicators can be shown on the screen.
A: The motion detector is recording
B: Present time and date
C: Recording time
D: Motion detection
AV Line
4
ENGLISH