Publicité
Les langues disponibles
Les langues disponibles
OPERATION
Paper / Credit Card Entry:
Shredding operation:
To begin shredding, locate the control switch on the unit and select the "Auto" mode. The Green LED
light indicates the shredder is "On" and ready to use. Press the designated "PUSH OPEN" area on the
handle of the cover to open and expose the paper feed slot (FIGURE 3). The cover will click into
a preset position where the "SHREDDER STATUS" line must align with the "READY"
setting.
READY:
The shredder is currently on STANDBY and ready to operate when paper is inserted.
With the feed slot now exposed, you can shred sheets of paper or 1 credit card per pass.
Special Feature:
ShredSafe™ technology is an added safety feature incorporated in this particu-
lar model. It is a new technology where the shredder is able to detect forced entry
and automatically cuts the power off, preventing further shredding.
Safe Mode
Ready to use
Disabled
CONTINUED NEXT PAGE
6
ENGLISH
OPERATION
NOTE:
• Always turn off and unplug the shredder when not in use.
• This shredder will shred staples and small paper clips. It is recommended that you remove paper
clips whenever possible to extend the lifespan of your shredder.
• Only shred credit cards by feeding them vertically i nto the middle of the entry, releasing when shred
ding begins. Never feed more than one credit card at a time.
LED Status Indicators:
FIGURE 3
• Ready (Power On):
The Green LED light indicates the shredder is "On" and ready to operate when paper is inserted.
• Overheat:
The Red LED light indicates the shredder has shred continuously beyond the maximum running time
and overheating, the unit will automatically shut off. If this happens, switch the shredder Off for 45
minutes or longer before resuming normal operation.
Feed slot close,
push to open.
Ready to operate.
Cover over tilt,
power shut off.
Ready / Overheat
ENGLISH
7
Publicité
