Publicité
Les langues disponibles
Les langues disponibles
Getting started
To connect to a TV with the component video input jacks
You can enjoy high picture quality by connecting the unit's COMPONENT VIDEO OUT jacks to the COMPONENT VIDEO
IN jacks of your TV with the video cables.
Note that the COMPONENT VIDEO OUT jacks are not active in the initial (factory preset) condition. See below for details
how to make them active.
Green
The unit
DIGITAL OUT
VIDEO OUT
PCM / STREAM
COMPONENT
Y
P
B
COAXIAL
RIGHT
S-VIDEO
VIDEO
AUDIO OUT
Red
• Connect "Y" to "Y," "P
Enabling the COMPONENT VIDEO OUT
For your TV connection, you can use either the component video output or the S-video output at a time.
When you use the component video output, set the VIDEO OUT SELECT (COMPONENT/S-VIDEO) switch on the rear
panel to "COMPONENT". Then, "COMPONENT" appears on the display window for a few seconds.
(Display Window)
Note that you must change the switch position while the unit is stopped, or the unit power is off. Otherwise, the changed
setting is not effective.
NOTES
• When the component video input jacks of the TV is the BNC type, use an adapter to convert a pin jack to a BNC jack (optional).
• When you use the component signal connection, the screen will become blue if setting is made to S-VIDEO. In this case, switch
the setting to COMPONENT.
• If you switch the VIDEO OUT SELECT switch while the unit power is off with a DVD inserted, depending on the DVD being
used, the unit may automatically start playback and the video out is not switched as you expected. In this case, press the 7 7 7 7
button. The unit stops and switching is correctly made according to your switch selection.
14
Blue
Component video cable
Red
(not supplied)
P
R
VIDEO OUT SELECT
S-VIDEO
COMPONENT
AND
VIDEO
LEFT
White
Audio cable (not supplied)
" to "P
," "P
" to "P
" correctly.
B
B
R
R
VCDVD
GROUP
TITLE TRACK CHAP
PROGRAM
RANDOM
TV
IN
White
Red
A - B
1
Blue
Green
Red
Y
P
P
B
R
S-VIDEO
VIDEO
IN
LEFT
AUDIO
RIGHT
Publicité
