Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
guidelines for Using Extension Cords
• If you are using an extension cord outdoors, be sure it is marked with the suffix "W-A" ("W" in
Canada) to indicate that it is acceptable for outdoor use.
• Be sure your extension cord is properly wired and in good electrical condition. Always replace a
damaged extension cord or have it repaired by a qualified person before using it.
• Protect your extension cords from sharp objects, excessive heat, and damp or wet areas.
Recommended Minimum Wire Gauge for Extension Cords (120 Volt)
Nameplate
Extension Cord Length
Amperes
25 Feet
(At Full Load)
0–2.0
18
2.1–3.4
18
3.5–5.0
18
5.1–7.0
18
7.1–12.0
18
12.1–16.0
14
16.1–20.0
12
SPECIFIC SAFETY RULES FOR ROTARY TOOLS
WARNINg:
(gAINED FROM REPEATED USE) REPLACE STRICT ADHERENCE TO
PRODUCT SAFETY RULES. If you use this tool unsafe or incorrectly, you can
suffer serious personal injury!
WARNINg:
an operation where cutting tools may contact hidden wiring or its own cord.
Contact with a "live" wire will make exposed metal parts of the tool "live" and
shock the operator!
• Use only accessories rated for the speed recommended
warning label or higher. Wheels and other accessories running at speeds greater than rated
can flay apart and cause personal injury.
• Always hold the tool firmly in your hands
reaction to the torque of the motor as it accelerates to full speed may cause the tool to twist.
• Be aware of the switch location
tool up. you may accidentally activate the switch.
• After changing the bits or making any adjustments, make sure the
collet nut and any other adjustments are securely tightened.
or unsecured adjustment devices can unexpectedly shift, causing loss of control, and loose
rotating components will be violently thrown.
• Do not reach in the area of the spinning bit
to your hand may not always be apparent or obvious.
• Brushes should be run at operating speed for at least one minute
before using
. No one is to be in front or in line with the brush during this time. This run-in
time allows loose wires and bristles to be discharged prior to work application.
Variable Speed Rotary Tool
Operator's Manual
50 Feet
75 Feet
18
18
18
16
14
12
10
DO NOT LET COMFORT OR FAMILIARITY WITH PRODUCT
Hold tool by insulated gripping surfaces when performing
100 Feet
18
18
18
16
16
14
14
12
12
10
10
10
8
8
before switching the tool "ON". The
when placing the tool down or when picking the
. The nearness of the spinning bit
GRT2103-40
150 Feet
200 Feet
16
16
14
14
12
12
12
10
8
8
8
6
6
6
on the tool
Loose
Publicité
Table des Matières
