PAJ GPS VEHICLE Finder 4G 1.0 Notice D'utilisation page 13

2.5 Installation
24
1.
Mount the FINDER
on the vehicle batte-
ry using the adhesive
strips.
2.
Connect the device to
the battery. Connect
the red cable with the
fuse to PLUS (+). Con-
nect the black cable to
MINUS (-).
NOTE!
When connected to the power supply, the Vehicle
Finder 1.0 switches on immediately and the LED lights
emit a signal. If the FINDER is not connected to the ve-
hicle battery, but at a different point (e.g. fuse box), this
can result in the ignition on / off function not being accu-
rately recognized.
Black cable
-
+
Red cable
ATTENTION!
The poles must never be reversed.
2.6 Turning on
After a successful activation you can switch on the
VEHICLE Finder 1.0. By connecting the FINDER to the power
supply the device has already been switched on.
It is recommended to start VEHICLE Finder 1.0 for the
first time in places where the vehicle is not covered
(not in the garage or similar).
-
Battery
9-75 V
+
25