Publicité
Les langues disponibles
Les langues disponibles
EN
11
TROUBLESHOOTING
Problem
The machine does
not start.
The bar and chain
gets hot and
smokes.
The bar and chain
gets too hot and
can not cut.
The motor runs,
but the chain does
not cut correctly,
or the motor stops
after around 3
seconds.
Possible cause
Solution
The poles are not
Assemble the
assembled cor-
poles according to
rectly.
the instructions.
1. Push and hold
the lock-out
button
2. While you
The lock-out but-
hold the lock-
ton and trigger are
out button,
not depressed at
pull the trig-
the same time.
ger.
3. Release the
lock-out but-
ton to start the
machine.
Oil tank is empty. Fill the oil tank.
1. Remove the
battery pack.
The discharge
2. Remove dirt
port is blocked.
from the dis-
charge port.
1. Clean the oil
tank.
Inlet opening of
inner oil tank is
2. Fill with clean
blocked.
bar and chain
lubricant.
The sprocket is
1. Clean the
stuck and clogged
sprocket.
with debris.
2. Fill with clean
bar and chain
lubricant.
The chain tension
Refer to Adjust
is too tight or too
the Chain Tension
loose.
in the manual.
Sharpen or re-
The chain is dull
place the chain.
Take out the chain
The chain is put
and turn it in the
on backwards.
right direction.
1. Release the
When you use the
trigger.
machine under
2. Start the ma-
load, it stops.
chine again.
Lubricate the
The chain is not
chain to decrease
lubricated.
the friction.
English
12
TECHNICAL DATA
Voltage
Guide bar length
Chain pitch
Chain gauge
Chain oil capacity
Weight (without battery
pack)
Chain
Guide bar
Battery model
Charger model
The recommended ambient temperature range:
Item
Appliance storage tempera-
ture range
Appliance operation temper-
ature range
Battery charging temperature
range
Charger operation tempera-
ture range
Battery storage temperature
range
Battery discharging tempera-
ture range
13
LIMITED WARRANTY
Greenworks hereby warranties this product, to the original
purchaser with proof of purchase, for a period of four (4)
years against defects in materials, parts or workmanship.
Greenworks, at its own discretion will repair or replace any
and all parts found to be defective, through normal use, free
of charge to the customer. This warranty is valid only for
units which have been used for personal use that have not
12
80V DC
10'' (254 mm)
1/4" LP (6.3 mm)
0.050''(1.27mm)
80 ml
9.9 lbs (4.5 kg)
25AP058X/Q5058
100SDAA041/
MQ501058-1041TL
2901302/BAB726 and other
BAB series
2901402 and other CAB
series
Temperature
32°F (0°C) - 113°F (45°C)
32°F (0°C) - 113°F (45°C)
39°F (4°C) - 104°F (40°C)
39°F (4°C) - 104°F (40°C)
32°F (0°C) - 113°F (45°C)
32°F (0°C) - 113°F (45°C)
GARANTIE OUTIL &
BATTERIE • GARANTÍA PARA
HERRAMIENTAS Y BATERÍAS
Publicité
