JB Systems Light LED MARVEL Mode D'emploi page 7

ENGLISH
12
13
Note: there is no "color off" status in SCENE mode.
In FLASH (STROBE) Mode: 5 strobe pattern presets can be chosen by consecutively pressing the
PT/COL key on the unit itself or the PT/COL up/down keys on the remote control:
Preset
01
02
03
04
4. SPEED button
By consecutively pressing this key on the main units itself, or by using the SPEED up/down keys on the
remote control, it allows the sequential choice of various speed settings, depending on which MODE the
unit operates in:

In CHASE mode: 1Hz / 2Hz / 4Hz fixed / S2L (with LED indicator)

In FADE mode: speed 0.25Hz fixed/ 0.5Hz fixed / 1Hz / 2Hz fixed

In MOOD mode: speed 0.05Hz fixed / 0.25Hz fixed/ 0.5Hz fixed / 1Hz fixed

In SCENE mode: no speed choice (this button disabled)

In FLASH (STROBE) mode: the strobe speed can bet set in 4 levels.
Note: the chosen speed setting will be stored for every mode, so once returning to the mode, the
previously chose speed will be recalled.
5. S2L (SOUND TO LIGHT) indicator
In chase mode you can use the SPEED-button select different speeds or you can choose to run the
patterns to the rhythm of the music, in this last mode the SOUND TO LIGHT indicator is lit.
6. ON/OFF indicator
Indicates if the LED Marvel is connected to the mains or not.
7. BASE
Used to mount the LED Marvel in many different ways: see the chapter "How to install" for more
information.
8. DMX in/out connectors
You can use the LED Marvel standalone, in master/slave or you can control it using an external DMX-
controller. Please check the chapter "How to connect" for more information.
9. Power adapter in/out
Used to connect the power adapter, you can connect 1 more LED Marvel on the same power adapter.
However the included power adapter does not support this. In short we suggest NOT using the power
adapter output.
10. Microphone
The internal microphone picks up the music so the chases can run to the rhythm of the music.
11. STANDBY (ON/OFF) button
Only available on the remote: sets the output in blackout mode (off). This has the same effect as setting
the level (button 1)
JB SYSTEMS
®
Candy
White (50% Level)
Preset Name Description
Strobe-All6- All 6 Segments strobe alternating with a 4-Flash cycle in red,
RGB-SEQ green, blue with 16 Hz
Strobe-All6-
All 6 Segments strobe alternating with a 4-Flash cycle in
PTL-SEQ pink, turquoise, lime with 16 Hz
Strobe-222- Segments 1+4 / 2+5 / 3+6 flash sequentially while in every
RGB-SEQ step the currently active segments keep strobing for 4
Flashes before the the next segments take over. The flash
color cycles through R/G/B
Strobe-222-PTL-
Segments 1+4 / 2+5 / 3+6 flash sequentially while in every
SEQ step the currently active segments keep strobing for 4
Flashes before the the next segments take over. The flash
color cycles through P/T/L
5/44
USER MANUAL
LED MARVEL