Publicité
Les langues disponibles
Les langues disponibles
Pre-Installation (continued)
INSTALLING SUPPORT BRACKETS
-
Draw a vertical center line (1) on the supporting wall up to the ceiling, or as
high as pratical, at the center of the area in which the hood will be installed .
-
Draw a horizontal line (2) above the range at the preferred distance between
26 - 36 in (660 -914 mm). Consult the user manual of your range if so
required .
-
Position the range hood support bracket (D) on the wall about 11 .8 in .
(300 mm) from the line (2) to the mounting holes, aligning the center with
the vertical reference line (1) . Mark the mounting hole locations .
-
Position the lower chimney support (F) on the wall about 17.94 in. (456
mm) from the range hood support bracket (D), aligning the center with the
vertical reference line (1) . Mark the mounting hole locations .
-
Position the mounting holes of the upper chimney support (E) on the wall
0.75 in. (19mm) from the ceiling, aligning the center with the vertical
reference line(1) . Mark the mounting hole locations . If the distance between
lower and upper chimney support bracket holes is more than 18 .8 in
(478 mm) then the range hood support bracket (D) and the lower chimney
support bracket (F) should be raised to ensure the upper chimney is
installed flush with the ceiling.
-
Check to ensure the supplied power cable is long enough to reach your
grounded electrical outlet. See "INSTALLING THE WIRING" for more details.
-
Once you are satisfied with the layout, drill pilot holes at the marked
locations .
INSTALLING THE WIRING
DANGER:
Risk of electrical shock . This range hood must be
properly grounded .
DANGER:
Turn off the power circuit breaker or the power
switch on the junction box before installing or servicing
this unit . Touching circuitry inside the range hood while it is
energized will result in death or serious injury .
DANGER:
All electrical wiring must be properly installed,
insulated, and grounded . Improper insulation and grounding
will result in deadly electrical shock .
-
It is the customer's responsibility to contact a qualified electrical installer
and assure that the electrical installation is adequate and complies with
the National Electrical Code, or CSA standards, as well as all local codes
and ordinances .
-
This range hood is equipped with a cable with a grounding wire and a
grounding plug . The plug must be plugged into an electrical outlet that is
properly installed and grounded .
-
The outlet shall be located within an area covered by the decorative
chimney as shown in figure 5.
IMPORTANT:
Installation work and electrical wiring must be done by a qualified
person(s) in accordance with all applicable codes and standards,
including fire-rated construction.
9
Please contact cs@conglomkb.com or 1-877-333-0098 for further assistance .
Ceiling
E
0.75 in. (19 mm)
6.5 in.
(165 mm)
18.8 in. or less.
(478 mm)
5.9 in.
F
(150 mm)
17.94 in.
(455.8 mm)
6.89 in.
(175 mm)
11.8 in.
(300.2 mm)
26 - 36 in.
(660 - 914 mm)
Fig. 4
Hood
Centerline
36 in. MAX
(914 mm)
3 in. MAX
(76 mm)
Fig. 5
CONGLOMKB.COM
Publicité
