Chillafish CPQD01 Guide D'utilisation page 3

Assembly instructions
For easy assembly, please use the images in appendix as your reference.
QUADIE
A. Please check that your box contains all parts shown in image A.
B. Assemble the rear wheels and make sure the bolt is secured.
C. Insert the steering axle into the frame tube.
D. Insert the handle bar into the steering axle. Take out the bolt and push the
plastic ring over the steering axle. Make sure the three holes are aligned.
E. Insert the hexagonal nut into the hexagonal hole.
F. Insert the bolt through the aligned holes and secure the bolt using a
hexagonal screwdriver.
G. Make sure the snaps on the caps are aligned with the sleeve in the plastic
ring. Click the covering cap into the snap holes.
Adjusting the seat height
H. There are no tools needed for adjusting the seat height into one of the three
positions. Follow these steps to adjust the seat.
1. Unscrew the seat fixer at the bottom of the seat and lift the seat from
the frame.
2. Choose a suitable seat height and fit the stubs in the frame holes. Secure
the seat fixer by screwing the nut.
TRAILIE
I. Assembly of Trailie
1. Assemble the axle to the Trailie and secure the bolt and nut
2. Assemble the two wheels and make sure the bolts are secured
J. Assembly of Connector: Use images as reference
EN
3