Publicité
Les langues disponibles
Les langues disponibles
Ø
Setting the Temperature Control
Your unit has only one control for regulating the temperature in the compartment. The temperature
control is located on the upper right hand side of the compartment.
The first time you turn the unit on, set the temperature control to "6". The range of the temperature
control is from position "0" to "6". After 24 to 48 hours, adjust the temperature control to the setting that
best suits your needs. The setting of "3 - 4" should be appropriate for home or office use.
To turn the refrigerator off, turn the temperature control to "0".
NOTE:
-
Turning the temperature control to "0" position stops the cooling cycle but does not shut off the
power to the unit.
-
If the unit is unplugged, has lost power, or is turned off, you must wait 3 to 5 minutes before
restarting the unit. If you attempt to restart before this time delay, the unit will not start.
NOTE:
·
IF THE UNIT IS UNPLUGGED, HAS LOST POWER, OR IS TURNED OFF, YOU MUST WAIT 3
TO 5 MINUTES BEFORE RESTARTING THE UNIT. IF YOU ATTEMPT TO RESTART BEFORE
THIS TIME DELAY, THE REFRIGERATOR-FREEZER WILL NOT START.
NOTE:
WE DO NOT RECOMMEND THE INSTALLATION OF THE REFRIGERATOR
WHERE THE TEMPERATURE WILL DROP BELOW 50ºF (13ºC) OR RISE ABOVE
110ºF (43ºC). THE COMPRESSOR WILL NOT BE ABLE TO MAINTAIN PROPER
TEMPERATURES INSIDE THE REFRIGERATOR.
Ø Defrosting Your Unit
Defrost the unit when the frost accumulated on the evaporator is about 5mm (1/5 inch) thick.
o
Remove frozen or perishable foods from the chiller compartment and place it in a cooler to
o
protect the food.
Move the top shelf to the top rack position and place the drip tray in place.
o
Simply press the DEFROST button in the middle of the temperature control knob, the refrigerator
o
will then begin to defrost. Once the defrost cycle has completed, the refrigerator will return to
normal operation automatically.
During the defrost cycle, the ice melts into the water drip tray.
o
To remove the water, either remove the water drip tray and/or place a collection container under
o
the tray. Use a sponge or towel to pick up the melting ice off the unit floor.
Dry the water collection tray and store in a convenient place for the next use. Defrosting usually
o
takes a few hours. After defrosting, return the thermostat dial to the desired position. To defrost
quickly remove all foods from the unit and leave the door open. Never use a knife or other metal
instrument to scrape ice/frost from the evaporator.
CAUTION: Do not use boiling water as it can damage the plastic parts. Also, never use a sharp or
metallic instrument to remove ice as it can damage the cooling coils and will void the warranty. It is
recommended to use a plastic spatula.
OPERATING YOUR APPLIANCE
9
Publicité
