LENCO Classic Phono TT-10 Mode D'emploi page 7

Les langues disponibles

1. Turntable deck

2. Turntable shaft

3. Center hole adaptor

4. Tone arm

5. Lift lever

6. Tone arm

7. Turntable speed selector

8. Auto stop control switch

9. LED power indicator

10. Power switch/ Volume control

11. Headphone jack

12. Stylus

13. Lock catch

14. Carrying handle

15. Speaker

16. Aux in jack

17. Line out channel R/L

18. DC in jack

Using the turntable

1. Place the turntable case on a flat level surface.

2. Insert the adaptor cord into the Dc jack at the rear of the case and plug the adaptor into the mains

supply socket.

3. On first use, ensure that the cable tie is removed from the player arm.

4. Remove the stylus cover and keep in a safe place for future use

5. Move the speed selector to the speed (33,45 or 78rpm) corresponding to the record to the played

6. Turn the Volume knob to turn the turntable on and the mode indicator will illuminate red

7. Place a record onto the turntable spindle and unclip the tone arm

8. Use the cuing lever to lift the tone arm and move the arm so that the stylus is positioned just inside the

edge of the record or aligned with the start of the track to be played.

9. Slowly lower the arm and after a short interval the record will start to play

10. Adjust the volume to the desired level by rotating the volume control knob