Chapin Tree/Turf Pro 62000 Manuel D'utilisation Et D'entretien page 3

APPLICATIONS & USE FOR YOUR SPRAYER
Avoid using a sprayer for general cleaning purposes if plant protection or herbicide chemicals have
already been used in the sprayer. If a sprayer has been used for plant protection or as an herbicide,
clean the sprayer completely (see cleaning section) before using.
Plant Food: Use different spray patterns for optimum foliage feeding or for fungicide and pesticide
application.
Herbicides: Reduce weeds and unwanted plants but avoid using the same sprayer for plant feeding or
protection without thoroughly cleaning (see cleaning section) the sprayer first.
General Household Use: Apply detergents, cleaning solutions, warm water (do not exceed
120°F/49°C) or nontoxic household cleaning chemicals for carpets, floors, walls, glass, counter tops and
ceilings. DO NOT use sprayer that has been used with herbicides, pesticides or other toxic chemicals for
household applications.
General Outdoor Use: Use the sprayer for cleaning windows or with a detergent for general purpose
cleaning.
SPRAYER COMPONENTS & USE INFORMATION
CF VALVE™ ASSEMBLY
Assemble nozzle gasket to inlet side of CF Valve™ and screw onto
the end of the elbow. Place the fan nozzle tip into the retaining nut
and then place the nozzle gasket on the fan nozzle tip flange. Screw
this assembly onto the outlet side of the CF Valve™. To uninstall
the CF Valve™, reverse the above instructions.
The CF Valve™ is intended to be used with a fixed nozzle. The Fan nozzle tip provided is rated @ .4 GPM @ 40psi.
NOZZLE ASSEMBLY
Figure 1-3
Unscrew the nozzle cap (1) from the nozzle body (3) with retaining nut (2) fastened tightly to the elbow (5). Unscrew the
retaining nut (2). Push the nozzle body (3) with the nozzle gasket (4) out of the retaining nut (2). To reinstall the nozzle,
reverse the above instructions.
Figure 4
Unscrew the retaining nut from the elbow and push the fan nozzle tip and gasket out of the retaining nut. To reinstall the
nozzle, reverse the above instructions.
1. Poly
Nozzle Cap
2. Retaining
Nut
3. Nozzle
Body
4. Nozzle
Gasket
5. Elbow
Adjustable Poly Nozzle
1. Brass
Nozzle Cap
2. Retaining
Nut
4. Nozzle
Gasket
5. Elbow
Figure 1
Elbow
1. Brass
Nozzle Cap
3. Nozzle
Body
Figure 2
Adjustable Brass Nozzle
2E
CF Valve™
(1.5 BAR-21 psi)
Outlet
(3/8 thread)
Inlet
(3/8 Thread)
Nozzle
Gasket
2. Retaining
Nut
3. Nozzle
Body
4. Nozzle
Gasket
5. Elbow
Figure 3
Extended Reach
Brass Nozzle
Fan
Nozzle Tip
Nozzle
Retaining
Gasket
Nut
Retaining Nut
Fan Nozzle Tip
Nozzle
Gasket
Elbow
Figure 4
Fan Nozzle