Rio Salon Laser LAHRC3000 Mode D'emploi page 6

Enter the security button sequence by pressing the buttons (highlighted in black) in the following order:
1
If the sequence is entered correctly the unit will emit 2 beeps and the keyswitch will stop flashing and light green. The lowest power level
will light blue and the SCAN and SINGLE buttons will both flash blue ready for selection.
Note: There is a 60 second time limit for entering the code. The unit will power off if the code is incorrectly entered or if you have
exceeded the 60 second limit (the keyswitch will change from flashing green to flashing orange and the unit will emit two low beeps).
Turn the key off, wait a few seconds and then turn the key back on and re-enter the button sequence.
All manuals and user guides at all-guides.com
S E C U R I T Y B U T T O N S E Q U E N C E
2 3
4
4