Plug And Play; Damper Wire; Use Of The Tilt-Swivel; Specifications - Sony CPD-17F03T Mode D'emploi

Plug and Play

This monitor complies with the DDC™1 and DDC2B, which
are the Display Data Channel (DDC) standards of VESA.
When a DDC1 host system is connected, the monitor
synchronizes with the V.CLK in accordance with the VESA
standards and outputs the EDID (Extended Display
Indentification) to the data line.

Damper Wire

Using a white background, very thin horizontal stripes on
the screen are visible as shown right. These stripes are
damper wires. These wires are attached to the aperture
grille inside the Trinitron tube and are there to damp
vibrations of the aperture grille in order to prevent them
from influencing to the picture quality.

Use of the Tilt-Swivel

With the tilt-swivel base, this unit can be adjusted to be
viewed at your desired angle within 90° horizontally and
20° vertically.
To turn the unit vertically and horizontally, hold it at its
bottom with both hands.

Specifications

Picture tube 0.25 mm aperture grille pitch, 17
inches measured diagonally (16"
visual), 90-degree deflection
Effective picture size Approx. 328 × 242 mm (w/h)
(13 × 9
Resolution Horizontal: Max. 1280 dots
Vertical: Max. 1024 lines
Display picture size Approx. 300 × 225 mm (w/h)
(11 7 /
6
5 / inches)
8
× 8
7 / inches)
8 8
When a DDC2B host system is connected, the monitor
automatically switches to the DDC2B communication.
DDC™ is a trademark of Video Electronics Standards
Association.
Damper wire
15°
45°
5°
Deflection frequency Horizontal: 31.5 to 64 kHz
Vertical: 50 to 120 Hz
AC input voltage/current
100 to 120 V, 50/60 Hz, 1.8 A
220 to 240 V, 50 – 60 Hz, 1 A
406 × 426.5 × 451 mm (w/h/d)
Dimensions
(16 × 16
Mass Approx. 19.0 kg (41 lb 14 oz)
Design and specifications are subject to change without
notice.
Approx. 6 cm
Approx. 6 cm
45°
× 17
7 / 7 / inches)
8 8