Kemper KE3008 Mode D'emploi page 9

2. Place the stove on a stable and horizontal surface.
3. Place the stove away from flammable liquids or in any case from objects that are affected by
heat.
4. Ensure that the burner handwheel is turned completely to the «-»
position. Remove cover of the cartridge and screw the cartridge on
the burner.
5. Open the gas tap a quarter of a turn in the «+» direction and fully
press the button for piezo ignition for models equipped with Piezo,
ignite with a flame for normal models.
6. To adjust the flow rate, turn the tap's handwheel towards the «-»
position to decrease the flow rate or towards the «+» position to
increase the flow rate.
7. After using the appliance, dose the gas tap by turning the handwheel
to the «-» position.
8. During long periods of operation, it is normal for the lower part of the
cartridge to cool down.Parts of the device may get very hot.
9. Do not move the cooker with the burner lit.
10. Do not move the cooker with a pan over it.
11. Never use with an empty container. Risk of cartridge overheating.
1. The gas cylinder must be replaced outdoors and in any case far from flames or flammable
substances.
2. Ensure that the appliance is switched off before you remove the cartridge.
3. Check that the cylinder tap is perfectly closed.
4. Unscrew the cartridge while holding the burner still: an internal valve prevents the gas from
escaping.
5. Examine the seals of the unit before installing a new cartridge.
6. Install a new cartridge as previously indicated
7. Inserting new cartridges in a cold appliance can lead to a change in the flame, which however
returns to normal after some time. The appliance must only be disassembled and packaged
when it has cooled down.
BEFORE USING CHECK THAT THERE ARE NO LEAKS.
Check the leakage of your device only outside. Do not seek the leakage with a match but use
water and soap or a gas detector (our article Revelgas cod. 1726).
Turn the tap on the gas bottle.
Apply solution of soap and water or gas detector in the interspaces of the unit.
If bubbles appear, it means that there is a leak and it must be repaired before use.
In the case of gas leaks immediately close the valve of the gas cylinder.
After making the repair, repeat the test.
If you detect a leak and you cannot repair it, don't try to fix it another way, but contact the
customer service. Never use the appliance if it leaks, is deteriorated or malfunctioning.
After conducting the test, close the gas supply to the tank.
DT Istr (KE3008/K3009) 10/2021 – Rev 1. 10/2021
REPLACING THE GAS CARTRIDGE
LEAKAGE TEST
KE3008 / KE3009
9/11