JUKI MS-1190/V045 Manuel D'utilisation page 44

A
A: V045, V046 In the case of the steel roller → 0.01 to 0.1 mm
V045, V046 In the case of the urethane roller
→ No clearance should be provided between
the roller and the throat plate.
1)
Loosen nut 1 . Adjust the clearance by turning
adjusting screw 2 .
In the case the steel roller is used:
Adjust the clearance provided between the roller and
the throat plate (bottom roller) to 0.01 to 0.1 mm.
In the case the urethane roller is used:
Adjust the clearance provided between the roller and
the throat plate (bottom roller) to 0 mm so that no
clearance is provided between them.
(V045)
– 11 –