JUKI MS-1190/V045 Manuel D'utilisation page 31

1. Keep your hands away from the needle when you turn the power switch ON or while the
machine is operating.
2. Do not put your fi ngers into the thread take-up cover while the machine is operating.
3. Keep your fi ngers, head hair or clothes away from the vicinity of the handwheel and thread take-
up lever or keep clean this area while the sewing machine is running.
4. Never operate the machine with the fi nger guard removed.
1. To achieve, security, be sure that the power supply earth wire has been connected before
operating the sewing machine.
2. Before inserting/removing the power plug, the power switch has to be turned OFF in advance.
3. In time of thunder and lightning, stop your work and disconnect the power plug from the
receptacle so as to ensure safety.
4. When you move the unit from a cold place directly to a warm place, dew condensation
may result. Turn ON the power to the unit after you have confi rmed there is no fear of dew
condensation.
5. To prevent fi res, periodically draw out the power plug from the plug socket and clean the root of
the pins and the space between pins.
6. The looper oscillates at a high speed while you are operating the sewing machine. To protect
your hands, keep your hands away from the vicinity of the looper. In addition, be sure to turn
the power OFF before threading the machine head.
7. To avoid possible accidents due to abrupt start of the machine, be sure to turn OFF the power
to the machine.
8. Be careful of handling this product so as not to pour water or oil, shock by dropping, and the
like since this product is a precision instrument.
CAUTION :
Note that safety devices such as "eye guard", "fi nger guard", etc. may be omitted from the
illustrations in this Instruction Manual for easy explanation.
When operating the machine, be sure not to remove these safety devices.
BEFORE OPERATION
CAUTION :
Check the following so as to prevent maloperation of and damage to the machine.
• Before you put the machine into operation for the fi rst time after the set-up, clean it thoroughly.
Remove all dust gathering during transportation and oil it well.
• Confi rm that voltage has been correctly set.
Confi rm that the power plug has been properly connected to the power supply.
• Never use the machine in the state where the voltage type is different from the designated one.
• The direction of normal rotation of the machine is counterclockwise as observed from the pulley side.
Take care not to allow the machine to rotate in the reverse direction.
• Never operate the sewing machine unless the sewing machine is suffi ciently lubricated.
• To operate the sewing machine, be sure to install the sewing machine on the table. Then, turn ON the
power switch.
• Be sure to remove thread from the machine head and looper before starting a trial run.
• Be sure to use your sewing machine with the speed of stitch lowered to 3,300 sti/min or less for the fi rst
month after installation.
• Operate the handwheel after the machine has totally stopped.
FOR SAFE OPERATION
v