Cisco Systems LINKSYS ADSL2 Guide D'installation Rapide page 2

1 Connect the ADSL2 Gateway
In Step 1, you will connect the Gateway
to your ADSL line and to the computers
in your home or business.
First, make sure that all the devices that
you'll be working with are powered
down, including your PCs and the
Gateway.
A
Connect one end of the provided
phone cable to the wall jack with
ADSL service.
To avoid interference, you
NOTE:
may need to place a
microfilter or splitter
between the phone
cable and wall jack.
Contact your service
provider for more
information.
B
Connect the other end of the
phone cable to the LINE port that
is on the back of the Gateway.
C
Connect one end of the provided
Ethernet cable to your PC's
Ethernet adapter. Connect the
other end of the cable to one of
the Ethernet ports on the back of
the Gateway. Repeat this process
for every PC that you want to
connect to the Gateway.
If you are connecting more than
four PCs to the Gateway, you will
also need to connect a hub or
switch to the Gateway.
If your PC's Ethernet
NOTE:
adapter is not set up, refer
to the Ethernet adapter's
user guide for more
information.
2
B
C1
C2