Husqvarna TS 148 Manuel D'utilisation page 12

8. Put the steering wheel adapter on the steering
shaft extension.
9. Put the steering wheel on the steering shaft
extension.
10. Make sure that the front wheels and the steering
wheel are aligned forward.
11. Install the large flat washer (H), the lock washer
(I), and the bolt (J). Tighten the bolt fully.
12. Attach the center cover (K) to the steering wheel.
The center cover is attached with snap locks.
To install the seat
1. Remove, but do not discard, the hardware which
attaches the seat to the cardboard package.
2. Remove and discard the cardboard package.
Note:
Do not remove the tape from the
adjustment handle until the seat is correctly
attached to the product.
3. Connect the wire connector to the safety switch
(A) on the seat.
C
D
B
4. Put the seat on the seat pan (B) and put the
middle plastic piece (C) into the middle slot
assembly hole (D).
12
5. Push the seat rearward until the 2 front plastic
6. Fold the seat forward and install the 2 bolts (F)
E
A
7. Remove the tape from the adjustment lever (I)
8. Do a check of the operator presence control.
pieces (E) are aligned with the front slot
assembly holes. Push down the seat to engage
the plastic pieces in the slots. Push the seat
rearward.
2
and the 2 washers (G).
F G
Note:
Make sure that the 2 front plastic pieces
(H) are fully engaged in the seat pan.
Note:
Make sure that the arrows on the 2
washers point up.
and discard the tape.
To do a check of the operator presence
Refer to
control (OPC) on page 7 .
WARNING:
product if the operator presence
control is defective.
1
H
I
Do no operate the
1947 - 005 - 19.10.2022