Publicité
2.
Error response status：(Only for service debug) :
Response : 0x05 0x14 0x00 0x16 0x00 0x00 0x00 ErrorStatus(20 Items) checksum
1．
Item 0 ~17: 1 byte.
2．
Item 18 : First burn In error minutes， 4 Bytes.
3．
Item 19: Lamp Status，1 Byte.
Item 20: Lamp error status，2 Bytes.
4．
Total : 32 Bytes 。
3.
When the projector response the code
For example when there are no source inputs to projector, the function "Aspect Ratio" is greyed out and can't be controled by user via OSD
menu or RC.
4. HDMI Range:
Enhanced = 0 – 255 steps
Normal = 16 -235 steps
5. This function is only applied some models due to LAN solution.
Status explanation:
Power On: System is finished all HW/FW settings and ready to work.
Warm Up: System is at initial stage to set and check HW/FW environment. Please do not perform other commands.
Cool Down: System is at final stage to close HW/FW environment. Please do not perform other commands.
Power Off: System is turned off all HW/FW except MCU or LAN functions with LAN standy setting.
*This command is only applied to particular models, please refer to User Guide.
6. The "Mute" function is only active when there is an input source applied.
The "Auto Adjust" function is only active when there is an input source of non-digital type applied, such as VGA/Computer1/D-sub.
"0x00
0x14 0x00 0x00 0x00 0x14" at the first byte
64
71 6 7
"0x00"
, it indicate that function is disable (grey out).
Publicité
