Publicité
Les langues disponibles
Les langues disponibles
How to Start:
1.
Place On/Off switch to "OFF".
2.
Plug the power cord into the
grounded outlet.
NOTE: Before turning the inflator on
know the desired pressure (measured
in PSI).
3.
Place On/Off switch to "ON" to
start inflator. If using the pressure
gauge watch it closely and when
it reaches the desired pressure
place the on/off switch in the
"OFF" position.
IMPORTANT: Watch inflatable
carefully while filling; do not overfill.
Cleaning
1.
Place the On/Off switch to "OFF"
and unplug the cord.
1.
Set the On/Off switch to "OFF"
and unplug the cord.
2.
Store accessories in the storage
bag located on back of unit. The
storage bag has a smaller
compartment to hold smaller
accessories.
Smaller
Compartment
3.
Wind the electrical cord loosely
around the inflator and snap it
onto itself for storage.
A02519
IIMPORTANT: While inflating objects the
pressure gauge will not read correctly.
Sometimes the gauge will read very high.
Turn th
needle to settle, this will provide an
approximate reading. Stop and check
the pressure reading frequently when
inflating.
NOTE: The pressure gauge on the
unit is for general reference only. To
ensure the most accurate pressure
reading use a separate pressure
gauge (not included) designed for the
object being inflated.
NOTE: When the unit has been
turned off, it is normal to hear a short
hiss of air being released.
MAINTENANCE
2.
STORAGE
4.
5.
14- ENG
e unit "off" and allow the
Wipe plastic parts clean using
mild soap and warm water.
Hose Snap
Coil the air hose around shroud
and snap into hose snap.
Store the inflator in a clean and
dry location.
Publicité
