Sage the Smart Oven Guide Rapide page 16

POSSIBLE PROBLEM EASY SOLUTION
The 'preheat' alert sounds
at a lower temperature than
what is displayed on the
LCD screen
The LCD screen displays
'E01'
The LCD screen displays
'E02'
The LCD screen displays
'E03'
The LCD screen displays
'E05'
Temperature are changing
when convection button
is pressed
16
• The 'preheat' alert sounds at 75% of the target temperature.
This provides the fastest, combined preheating and cooking time.
• This is because when the 'preheating' alert sounds, signalling
the user to open the oven door and insert food, there is dramatic
temperature loss inside the oven. If the alert sounded at 100%
of the target temperature, opening the door would mean a lot of
this waiting time is "wasted". We have calculated that by sounding
the alert at 75% of the target temperature, followed by the oven
door being opened to place food inside the oven, that we still
recover to the target temperature up to 2 minutes faster. This is
why the temperature on the LCD screen does not match the target
temperature at the 'preheat' alert. Depending on the set temperature,
it can take the oven approximately 8–10 minutes from start-up,
including opening the oven door when the 'preheat' alert sounds,
to reach the target temperature.
• The LCD screen will display 'E01' when there is a non-resettable
issue with the appliance. Should this occur, immediately remove the
power cord from the power outlet and call Sage Consumer Support.
• The LCD screen will display 'E02' when there is a non-resettable
issue with the appliance. Should this occur, immediately remove the
power cord from the power outlet and call Sage Consumer Support.
• The LCD screen will display 'E03' if the oven temperature is above
the set maximum limit. Remove the plug from the power outlet,
allow the oven to cool for 15 minutes, then plug back in.
• Call Sage Consumer Support if the 'E03' message continues.
• The LCD screen will display 'E05' when there is a non-resettable
issue with the appliance. Should this occur, immediately remove the
power cord from the power outlet and call Sage Consumer Support.
• This is normal. The temperature is calibrated to compensate
for the convection fan increasing cooking rates.