Create CRYSTAL Manuel D'utilisation page 9

• Turn on the heater by pressing the power button. The LED will display room temperature, then
please use touch control or remote control to set power, temperature and time.
• If the appliance is not used for a long time, switch the power button off and unplug the ap-
pliance.
Insert the plug in a suitable power socket. The touch screen buttons located on the product cor-
respond to the remote control functions.
1. Mode
2. Temperature
3. Power
4. Display
5. Timer
Power
When the product is on, press "power". The upper part of the display shows temperature. The
heater is working at low power heating conditions.
Mode
It enters heating mode.
ºC
Temperature
Press temperature button. The temperature can be set from 5 °C to 40 °C.
Internal temperature is displayed every time the appliance is started up. The temperature
can be set when the appliance is on stand-by or heating. When the room temperature reach-
es the set level, the high temperature power stops and the low temperature power remains
active. When room temperature is two degrees over the set temperature, both the high and
lower temperature powers will stop operating. The machine will begin operating again only
when temperature decreases two degrees with respect to the set temperature.
Timer
The timer button can be set to start or stop the appliance at the desired time, with a time
interval between 1 and 24 hours.
HOW TO USE THE TOWER RACK
CONTROL PANEL
1
ºC
2
3
4
5
E NGLI SH
9