Create CRYSTAL Manuel D'utilisation page 8

Follow the steps below for the correct installation of the towel rail:
1. Mark the installation holes on the wall parallel to the floor
as shown in the picture, remember that the wall must su-
pport the weight of the towel rail.
2. Drill the holes with a 10mm drill bit and not less than 60mm
deep, make sure the hole is vertical with the wall and the
lateral and vertical distance between the holes is correct.
Warning: To avoid risk to small children, this appliance must
be installed so that the lowest rail is at least 600mm from
the floor.
Brackets
3. Fix the 3 brackets on the wall with the expansion screw.
Please note that the fixed brackets can be moved to adjust
the position to fix the glass panel.
4. Remove the protective film on the back of the glass, then
install the glass panel on the fixed bracket on the wall.
Please note that you can adjust the position of the fixed
bracket on the wall to install the glass panel. Then tighten
the screws on the side of each support cover.
5. Upon completion of installation, connect the towel rack to
the power source to test the appliance and ensure it is wor-
king properly.
6. Remove the protective film from the glass front surface of
the appliance and press the power switch at the bottom of
the appliance to check that the towel rack works properly.
Mounting the towel rails:
• Attach one of the shelves by snapping it into the wall
brackets.
• Secure the shelf with the M4x10 screws and tighten them so
that they are secure.
• Follow the same steps to place the second towel rack shelf.
E NGL I SH
8
INSTALLATION INSTRUCTIONS
490 mm
785 mm
ø10mm
>600 mm