Husqvarna PW 240 Manuel D'utilisation page 17

3. Disengage the power trigger lockout. Refer to
engage and disengage the power trigger lockout on
page 17 .
4. Push the power trigger and keep it pushed in until
water comes out of the nozzle on the spray lance.
(Fig. 37)
To disconnect the product from the water
source
1. Turn the power switch to the off (0) position.
2. If the product is connected to the water mains, close
the valve on the water mains.
3. If the product is connected to the water mains,
disconnect the garden hose from the water mains.
(Fig. 38)
4. If the product is connected to an open water source,
remove the suction hose from the water source.
5. Push the power trigger and keep it pushed in until no
water comes out of the nozzle.
6. Disconnect the garden hose from the water inlet on
the product. (Fig. 39)
Note:
If the product is connected to an open water
source, disconnect the suction hose.
7. Push the tab in the direction of the quick connection
on the spray handle and pull out the high-pressure
water hose. (Fig. 22)
8. Turn the power switch to the on (I) position. Let the
product operate until no water comes out of the high-
pressure hose.
9. Turn the power switch to the off (0) position.
10. Let the spray handle, the spray lance, and the
nozzles become dry before you put the product in
storage.
To engage and disengage the power
trigger lockout
• To engage the power trigger lockout, push the button
to the locked position. (Fig. 40)
• To disengage the power trigger lockout, push the
button to the unlocked position.
To start the product
1. Connect the product to a water source. Refer to
connect the product to a water source on page 16 .
2. Connect the power plug to a power source.
1855 - 008 - 02.05.2023
To
3. Turn the power switch to the on (I) position. (Fig. 41)
4. Disengage the power trigger lockout. Refer to
engage and disengage the power trigger lockout on
page 17 .
5. Push the power trigger on the spray handle.
Note:
release the power trigger.
To stop the product
Note:
The product stops automatically when you
release the power trigger.
1. Release the power trigger on the spray handle.
2. Engage the power trigger lockout. Refer to
engage and disengage the power trigger lockout on
page 17 .
3. Turn the power switch to the off (0) position. (Fig. 42)
4. Disconnect the power plug from the power source.
5. Disconnect the product from the water source. Refer
To disconnect the product from the water source
to
on page 17 .
Note:
water source if you go away from the product for
more than 5 minutes.
To use the foam sprayer
1. Remove the foam sprayer from its holder. (Fig. 43)
2. Fill the container on the foam sprayer with cleaning
agent.
3. Push the quick connection on the foam sprayer into
the quick connection on the spray lance until it locks
in position. (Fig. 44)
Note:
with the groove in the spray lance.
4. Connect the product to a water source. Refer to
To
connect the product to a water source on page 16 .
5. Start the product. Refer to
page 17 .
The product stops automatically when you
Always disconnect the product from the
CAUTION:
Use only cleaning
agents that are recommended by
Husqvarna.
The flange on the foam sprayer must align
To start the product on
To
To
To
17