AEI Security & Communications DigiSender XD-2KM Mode D'emploi page 10

(EN) ENGLISH
DGXDSDV111SMA-2KM/DGXDSDV112SMA-2KM - 2000m Digital AV Sender System
continued...
5.
The DigiSender® XD Boot Screen will be displayed
whilst the Receiver locks on to the Transmitters
signal.
7.
You will notice that at the top right corner of the
screen is a blue Test Bar with some information on
it. If the Test Bar is not present, then your Receiver
may not be in Test Mode. Flick the Mode Switch on
the back from Normal to Test and turn the receiver
off and then back on again.
Page 10
All manuals and user guides at all-guides.com
6.
After approximately 5 seconds the picture will
change to whatever you are transmitting. If the pic-
ture does not change, or changes to the DigiSender®
Test Card, you may need to re-sync the Transmitter
and Receiver. See page 13 for more details.
8.
The first number indicates the Frame Rate that the
Receiver is picking up from the Transmitter and out-
putting to your TV.
Please read the instructions carefully prior to installation