Bosch Universal Rotak 650 Notice Originale page 14

14 | English
For increased electrical safety use a
Residual Current Device (RCD) with a
tripping current of not more than
30 mA. Always check your RCD every
time you use it.
Keep the supply cables away from
moving hazardous parts and avoid
damage to the cables; this can lead to
contact with live parts.
The connections (plugs and sockets)
should be kept dry and off the ground.
The supply cables must be inspected
for signs of damage at regular intervals
and may only be used if in perfect con-
dition.
If the supply cable on the product is
damaged, it must only be replaced by
a Bosch Service Centre. Only use ap-
proved extension cables.
Use only extension cords, cables,
leads and cable reels that comply with
EN 61242/IEC 61242 or IEC
60884-2-7 and are of type H05VV-F
or H05RN-F.
If you want to use an extension cable
when operating your product, only the
following cable dimensions should be
used:
– Nominal conductor area of
2
1.25 mm or 1.5 mm
– Maximum length 30 m for a Cord
Extension Set or maximum length
of 60 m for a Cable Reel with Re-
sidual Current Device (RCD).
Note: If an extension cable is used it
must be earthed and connected
through the plug to the earth cable of
1 609 92A 5W8 | (15.07.2020)
your supply network in accordance
with prescribed safety regulations.
If in doubt contact a qualified electri-
cian or the nearest Bosch Service
Centre.
plug and socket must be of water-
tight construction and intended for
outdoor use.
Maintenance
Always wear gardening gloves
u
when handling or working near the
sharp blades.
Keep all nuts, bolts and screws tight
u
to ensure safe working with the
product.
Check the grass catcher frequently
u
for wear or deterioration.
Inspect the product and replace
u
worn or damaged parts for safety.
Ensure replacement cutting means
u
of the right type are used.
Ensure replacement parts fitted are
u
Bosch-approved.
Before storing, make sure that the
u
product is clean and free of residue.
2
If necessary, clean with a soft dry
brush.
Symbols
The following symbols are important for reading and under-
standing the original instructions. Please take note of the
symbols and their meaning. The correct interpretation of the
symbols will help you to use the product in a better and safer
manner.
WARNING! Inadequate ex-
tension cables can be dan-
gerous. Extension cable,
Bosch Power Tools