Uline Glo Brite H-9409 Mode D'emploi page 3

CEILING MOUNTING
1. Mark pilot hole locations on ceiling using mounting
holes in mounting bracket. (See Figure 5)
Figure 5
Mounting Hole
2. Drill pilot holes in ceiling surface.
3. Remove the top channel of frame by removing the
screws on both ends. (See Figure 6)
Figure 6
4. Slide mounting bracket through the top channel.
(See Figure 7)
Figure 7
5. Insert provided screw into mounting bracket center
hole and secure. Fully tighten. (See Figure 8)
6. Put top channel back on with the two screws that
were removed in Step 3. (See Figure 8)
PAGE 3 OF 9
MOUNTING CONTINUED
Mounting Bracket
Screw
Top Channel
Mounting
Bracket
1-800-295-5510
uline.com
Figure 8
7. Level and mount sign to ceiling. Screw four screws
(not provided) through mounting holes in mounting
bracket to secure to ceiling.
BACK MOUNTING
1. Mark pilot hole locations on wall using mounting
holes in mounting bracket. (See Figure 9)
Figure 9
Mounting Hole
2. Drill pilot holes in wall surface.
3. Level and mount mounting bracket to wall. Screw
four screws (not provided) through mounting holes in
mounting bracket to secure to wall.
4. Snap the sign onto the mounting bracket.
(See Figure 10)
Figure 10
Screw
Mounting Bracket
1122 IH-9409