Télécharger Imprimer la page

Raider Industrial RDI-DH01 Manuel D'instructions Original page 11

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 48
if you hold it by hand.
1.5.13. Keep your workplace clean.
Mixtures of different materials are particularly hazardous. Fine shavings from light metals can be
self ignite or explode.
1.5.14. Do not use the demolition hammer, where the power cord is damaged. If during operation
the cable is damaged, do not touch. Immediately disconnect the plug from the outlet.
Damaged power cables increase the risk of electric shock.
1.5.15. If the demol. hammer is to be operated at low temperature or after long storage, allow the
hammer to operate for few minutes without load, for its internal elements get properly lubricated.
2. Functional description and purpose of the demolition hammer
The machine is designed for chiseling in concrete, brick, asphalt and stone.
Operate the auxiliary handle by turning the lower part of handle in counterclockwise direction and
rotate the extra handle to the desired one position. Then tighten the bottom of the extra handle again
turn clockwise.
3. Before work
3.1. Power Source
Make sure the power source to be used shall meet the power requirements specified in the rating
plate
demolition hammer data.
3.2. Switch trigger
Make sure the power switch is set to OFF. If the plug is connected to the power supply when the
power switch is ON , the breaker will start working immediately, which can cause a major accident!
4. Loading and removing the working tool (chisel)
Work with this demolition hammer using moderate force. Efficiency will be better if a moderate
force is applied to the handle against the work surface without pressing the machine.
5. Maintenance and verification
How to change the grease
This demolition hammer is airtight to prevent dust and prevent leakage. That's why this demolition
hammer can be used without lubrication for a long time.
After the purchase, each time before use, please make sure there is enough lubricant. The amount
in the tank is enough for 50 hours of work!
Before performing any maintenance, be sure to disconnect the plug
5.1. Checking of the instruments.
Using a worn accessory will result in worse results and engine faults. Replace the accessory
immediately.
5.2. Inspect the mounting screws
Regularly check all mounting screws and make sure they are properly tightened.
5.3. Checking the accessory / tool holder.
The holder may loose due to excessive use.
Carefully clean the tool queue and grease it with grease. Turn the latch
to 180 ° and place the tool in a rotating motion in the hole. Release the
retainer to lock the tool. Check the lock by pulling the tool (chisel, cutter)
Removing
Whirligig the stop pin to 180° and remove the tool.
11

Publicité

loading