Publicité
Les langues disponibles
Les langues disponibles
EN
IMPORTANT:
Never start the product without water in the
water bath.
NOTE:
•
The pump may make a sound when the
product starts up and the water begins
to circulate. This stops after 5 to 10
seconds.
•
Make sure the water level in the water
bath is between the MIN and MAX
marks.
•
If the product is making more noise than
it should during cooking, this may be
because impurities have entered the
pump. If this happens, stop the product
and clean it. Then restart and continue
cooking.
MAINTENANCE
CLEANING
Dry the interior of the water bath with a soft
cloth.
NOTE:
•
Never immerse the product in water or
any other liquid.
•
Do not use strong or abrasive
detergents.
•
Do not wash the product in a
dishwasher.
If impurities have entered the
pump
1.
Empty the water bath and remove the
cover from the pump using a screwdriver.
2.
Pour clean water, with some washing-up
liquid if necessary, into the water bath and
start the product. The circulating water
will gradually remove the impurities.
3.
When the impurities have been removed,
turn off the product and pour out the
water.
20
TROUBLESHOOTING
The product will not start
•
Make sure the product is plugged into
the mains power and that the power
outlet is working.
•
Press the START/STOP button to start. If
the product does not start, reposition
your finger and press again.
The product beeps during operation
If the water level in the bath drops below the
MIN mark during operation, the product will
beep and display error code E04. Check the
water level and add more water if necessary.
The temperature varies by more than 0.3°C
•
Make sure the water level in the water
bath is at least up to the MIN mark.
•
Make sure no food bags are touching
the bottom of the water bath, blocking
the slots in the base of the rack or
preventing water from circulating
around the edges of the water bath.
The display turns off and does not turn on
again
•
Make sure there is water in the water
bath. If the product was started without
water, unplug the product from the wall
and allow it to cool. When the product
has cooled, it can be used as normal.
•
Make sure that both ends of the power
cord are connected properly.
Publicité
